AltiGen comm ACM 5.1 manual Mobile Extension Board Configuration dialog box

Chapter 18: Mobile Extension Configuration

Figure 7. Mobile Extension Board Configuration dialog box

•Max Number of Extensions—If more mobile channel support is required, change this to a larger number (256 extensions maximum), and then reboot the system.

•Key Simulation—Check the first check box to allow the mobile phone user to use the * key to simulate “FLASH”. Check the second check box to allow the user to use ** to disconnect the current call and then get a dial tone without hanging up the cell phone. The user must press the second * within 1.5 seconds.

•“Transmit Caller ID to MobileExt through PRI” panel. Choose from:

•Send inbound caller ID or extension number

•Send inbound caller ID only

•Replace with following number

•DNIS Access Numbers—If a PRI trunk is used for a mobile extension, a DNIS access number must be set, so that AltiServ can tell if the incoming call is a regular trunk call or a mobile extension off-hook request. Click the Add button in this panel to add a DNIS access number. To remove a number, select it and click the Remove button.

•Mobile Extension Ports table —displays fields for the channel, target phone number, caller ID, trunk allocation (shared or dedicated), phrase 1 (Play Phrase After Answered), and phrase 2 (Play Phrase Before Dial Tone) of each extension port.

•Mobile Trunks table—displays fields for the board, span, channel, trunk allocation, mobile extension and status of each mobile trunk.

246AltiWare ACM 5.1 Administration Manual