AltiGen comm ACM 5.1 Setting the Line Properties, Assigning a Location to a Physical Extension

Chapter 15: Extension Configuration

Assigning a Location to a Physical Extension

When changing a virtual extension to a physical extension, the Location parameters are available. If you know which board and channel this extension is wired to, you can use the Prev and Next buttons to select the correct board and channel number for this physical extension.

Changing the Location

To change the location of a physical extension, select the extension number in the list of extensions, then click the Prev or Next buttons to change the board and channel settings until the location you want is displayed. Like other changes, this change isn’t finalized until you click Apply.

Setting the Line Properties

For a physical extension, you can configure hardware options on the port used for the extensions. To do so, select the extension number in the list of extensions, then click the Line Properties button to open a dialog box that is specific to the board used for the extension.

The Line Properties are somewhat different for Quantum Board than for Triton Analog Station Boards. The subsequent sections deal first with Quantum, then with Triton Analog Station.

Quantum Line Properties

If you select a Quantum board extension and click Line Properties, you’ll see the Quantum Line Properties dialog box.

Figure 2. Quantum Line Properties dialog box for extensions

AltiWare ACM 5.1 Administration Manual 199