AltiGen comm ACM 5.1 manual Parameter Description General, Debug

Chapter 17: AltiGen IP Phone Configuration

The left side of the IP Phone Configuration window displays all the IP phone extensions that have been set up in the system. The status "Inactive" means the Enable IP Extension box is checked for this extension in the Extension Configuration window, but there is no IP phone logged in to the extension. The extension may be a physical extension using an analog phone, a MobileExt, or a virtual extension.

After creating the IP extensions, you can set the following parameters on the General tab:

Parameter	Description
General	Lets you specify the IP address of the AltiServ system the IP
	phone is connected to. The version of firmware associated with
	the IP phone is automatically displayed in the Version field.
	To protect the configuration on the IP phone, check the Enable
	Configure Password check box and assign a numerical
	password. When the user presses the Menu button on the IP
	phone to access the phone configuration menu, the user will
	need to enter the assigned password. You can use this check
	box for two purposes:
	• If you publish the configuration password to the user, only
	the phone user would be able to change the phone
	configuration.
	• If you do not publish the configuration password, you can
	block the phone user from changing the phone
	configuration.
Default	Lets you set the digit required to enable a user to return an
Trunk	outside call from the Call Log. The default trunk access code
Access	can be the route access code, if it is set in AltiWare
Code	Administrator.
Debug	This is for debugging the IP phone using Telnet. You need to
	enter a Diagnostic password when logging in to AltiWare Admin
	(before you enter your Admin password) to enable this
	configuration.
Time	• Offset—a per phone-based configuration that allows a
Display	remote IP phone to display a different time, based on
	location. The offset is the time difference, in hours, between
	the AltiGen system and the IP phone.
	• Format—a per-phone-based configuration that allows the
	IP phone to display the time in one of the following formats:
	24 hour (example: 13:15), 12 hour AM/PM (example: 1:15
	PM), or AM/PM 12 hour (example: PM 1:15).

234AltiWare ACM 5.1 Administration Manual