Polycom DOC2702A, RMX 1500 manual IP only, While the endpoint is connected

Chapter 8-Address Book

Table 8-3New Participant – General Properties (Continued)

Field	Description
Endpoint Website IP	Enter the IP address of the endpoint’s internal site to enable
Address	connection to it for management and configuration purposes.
(IP only)	This field is automatically completed the first time that the endpoint
	connects to the RMX. If the field is blank it can be manually
	completed by the system administrator. The field can be modified
	while the endpoint is connected
Audio Only	Select this check box to define the participant as a voice participant,
	with no video capabilities.
Extension/Identifier	Dial-out participants that connect to an external device such as
String	Cascaded Links or Recording Links may be required to enter a
	conference password or an identifying string to connect. Enter the
	required string as follows:
	[p]…[p][string]
	For example: pp4566#
	p - optional - indicates a pause of one second before sending the
	DTMF string. Enter several concatenated [p]s to increase the delay
	before sending the string. The required delay depends on the
	configuration of the external device or conference IVR system.
	String - enter the required string using the digits 0-9 and the
	characters * and #. The maximum number of characters that can be
	entered is identical to the H.323 alias length.
	If the information required to access the device/conference is
	composed of several strings, for example, the conference ID and the
	conference password, this information can be entered as one string,
	where pauses [p] are added between the strings for the required
	delays, as follows:
	[p]…[p][string][p]…[p] [string]...
	For example: p23pp*34p4566#
Extension/Identifier	The RMX automatically sends this information upon connection to the
String (continued)	destination device/conference. The information is sent by the RMX as
	DTMF code to the destination device/conference, simulating the
	standard IVR procedure.

4Usually, additional definitions are not required and you can use the system defaults for the remaining parameters. In such a case, click OK.

To modify the default settings for advanced parameters, click the Advanced tab.

Polycom, Inc. 8-11