Polycom DOC2702A, RMX 1500 manual Set the Mintipcompatibilitylinerate System Flag

Appendix I-Polycom Open Collaboration Network (POCN)

iIn the Outbound Proxy Servers table, the Port field must be set to 5061. (The same value as entered in Step g.)

For more information see the Polycom Unified Communications Deployment Guide for Microsoft Environments.

4Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag.

The MIN_TIP_COMPATIBILITY_LINE_RATE System Flag determines the minimum line rate at which a Profile can be TIP enabled.

CTS version 1.7 requires a minimum line rate of 1024 kbps and will reject calls at lower line rates, therefore the System Flag value must be 1024 or higher.

For more information see "Modifying System Flags” on page 22-1.

5Reset the MCU.

6For more information see "Resetting the RMX” on page 21-69.

7Register the DMA to the Lync server

For more information see the Polycom Unified Communications Deployment Guide for Microsoft Environments, “Configure a DMA System SIP Peer for the Lync Server”.

8Register the ITP endpoints to the Lync server

For more information see the Polycom Unified Communications Deployment Guide for Microsoft Environments, “Deployment Process for Polycom Immersive Telepresence Systems”.

9Register Lync Clients to the Lync server

For more information see the relevant Lync documentation.

10Register DMA to the CUCUM server

For more information see the Polycom Unified Communications Deployment Guide for Cisco Environments, “Using a Polycom DMA System in a Cisco Environment”.

11Register CTS1000 and CTS3000 endpoints to the CUCUM server For more information see the relevant Cisco documentation.

12Register ITP endpoints to the CUCM server.

Polycom, Inc. I-31