Chapter 23-RMX Hardware Monitoring
Polycom, Inc. 23-31
7The selected tests are initialized. In the Tests Monitoring pane there is an indication of
the Connection Status of the Tests.
8This process may take some time. Click Stop Running Test to end all the diagnostic tests.
The MCU completes the current test running and then stops all remaining tests.
9The Diagnostics Mode can be exited by pressing the yellow System Reset icon. The RMX
then resets.

Diagnostics Monitoring

A hardware component’s test status can be viewed in the Diagnostics Test Monitoring
section before, during and after tests have been initiated. Test results will only be displayed
after tests are completed. The Diagnostic Tests Monitoring section is comprised of three
tabs: MCU Monitor, Cards Monitor and Error Buffer, which are further described below.

MCU Monitor

The MCU Monitor tab lists the status of all the cards that can be tested in Diagnostic Mode.
Described below are the columns:
Run All Test Runs all tests listed in the TestActive column for the hardware
component.
Table 23-20 Tests Selection - Additional Test Parameters (Continued)
Parameter Description
Connection Status