
112CHAPTER 15: ROUTING CONFIGURATION GUIDE
Network Diagram Figure 31 | Network diagram for (totally) NSSA area configuration | |||||
Switch A | Area 0 | Switch B | ||||
|
|
|
|
| ||
| 10.1.1.1/24 |
|
|
| ||
|
|
|
|
| ||
|
| 10.1.1.2/24 |
| |||
|
|
|
| 10.3.1.1/24 | ||
| 10.2.1.1/24 |
|
|
| ||
|
|
|
|
| ||
Area 1 |
| Area 2 | ||||
NSSA |
| 10.3.1.2/24 | ||||
10.2.1.2/24 |
|
|
| |||
| ASBR |
| Vlan- int300 | ASBR | ||
|
|
|
| |||
|
|
| 10.5.1.1/24 | Switch D | ||
Switch C 10.4.1.1/24 |
|
Networking and Run OSPF on the network devices. Based on actual conditions, you can configure Configuration an (totally) NSSA area to reduce the routing table size in the area.
Requirements
Applicable Products
Product series | Software version | Hardware version |
|
|
|
Switch 5500 | Release V03.02.04 | All versions |
Switch 5500G | Release V03.02.04 | All versions |
Switch 4500 | Release V03.03.00 | All versions |
|
|
|
Configuration Procedure
■Configure Switch A.
#Create VLANs and configure IP addresses for the VLAN interfaces. The configuration procedure is omitted.
#Configure OSPF for area 1.
<SwitchA>
[SwitchA] ospf 1
# Configure OSPF for the backbone area.
■Configure Switch B (refer to “Configure Switch A.” on page 112).
■Configure Switch C.
#Create VLANs and configure IP addresses for the VLAN interfaces. The configuration procedure is omitted.
#Configure a static route of 2.0.0.0/8.