260CHAPTER 28: POE/POE PROFILE CONFIGURATION GUIDE
Configuration Procedure # Upgrade the power processing software.
<SwitchA>
[SwitchA] poe update refresh 0290_021.s19
Update PoE board successfully
#Enable the PoE feature on ports Ethernet 1/0/1, Ethernet 1/0/2 and Ethernet 1/0/8.
[SwitchA] interface Ethernet 1/0/1
#Set the maximum power that Ethernet 1/0/1 and Ethernet 1/0/2 can provide for all PDs to 12000 and 2500 milliwatts respectively.
[SwitchA] interface Ethernet 1/0/1
#Set the PoE priority of Ethernet 1/0/8 to critical to guarantee power supply to the device connected to Ethernet 1/0/8.
[SwitchA] interface Ethernet 1/0/8
#Set the power supply management mode of the switch to auto (The default power supply management mode is auto, and this step can be omitted.).
[SwitchA] poe power-management auto
#Enable the PD compatibility detection function to allow the switch to supply power to the PDs not compliant with the 802.3af standard.
[SwitchA] poe legacy enable
#View the power supply status of all the ports on the switch after the configuration.
[SwitchA] display poe interface |
|
|
|
| ||
PORT INDEX | POWER ENABLE | MODE | PRIORITY | STATUS |
| |
Ethernet1/0/1 | on | enable | signal | low | Standard PD was | detected |
Ethernet1/0/2 | on | enable | signal | low | Standard PD was | detected |
Ethernet1/0/3 | off | enable | signal | low | detection is in | process |
Ethernet1/0/4 | off | enable | signal | low | detection is in | process |
Ethernet1/0/5 | off | enable | signal | low | detection is in | process |
Ethernet1/0/6 | off | enable | signal | low | detection is in | process |
Ethernet1/0/7 | off | enable | signal | low | detection is in | process |
