3Com 5500G, 4210, 4200G manual # Create detected group, # Configure a static route to Switch C

68CHAPTER 13: AUTO DETECT CONFIGURATION GUIDE

■Create detected group 9 on Switch C; detect the reachability of IP address 10.1.1.3, with the next hop being 192.168.1.1/24, and the detecting number being 1.

Applicable Products

Product series	Software version	Hardware version
Switch 5500	Release V03.02.04	All versions
Switch 5500G	Release V03.02.04	All versions
Switch 4500	Release V03.03.00	All versions

Configuration Procedure Configure IP addresses for the interfaces according to Figure 19. The configuration procedure is omitted here.

■Configure Switch A

# Enter system view.

<SwitchA> system-view

# Create detected group 8.

[SwitchA] detect-group 8

#Detect the reachability of 10.1.1.4, with the next hop being 192.168.1.2, and the detecting number being 1.

[SwitchA-detect-group-8] detect-list 1 ip address 10.1.1.4 nexthop 1

92.168.1.2

[SwitchA-detect-group-8] quit

# Configure a static route to Switch C.

[SwitchA] ip route-static 10.1.1.4 24 192.168.1.2

#Configure the master static route, which is valid when the detected group is reachable.

[SwitchA] ip route-static 10.1.3.1 24 192.168.1.2 detect-group 8

#Configure the backup static route, and set its preference to 80. The backup route is valid when the detected group is unreachable.

[SwitchA] ip route-static 10.1.3.1 24 192.168.3.2 preference 80

■Configure Switch C

# Enter system view.

<SwitchC> system-view

# Create detected group 9.

[SwitchC] detect-group 9