3Com 5500G, 4210, 4200G manual Outputting Log Information to Console, # Enable terminal display

Outputting Log Information to the Console 317

Precautions On the Windows operating system, software settings vary with log host software.

Outputting Log

Information to the

Console

Network Diagram Figure 108	Network diagram for outputting log information to the console
	Console
PC	Switch

Networking and Log information with a severity higher than informational will be output to the Configuration console, and the information source modules are ARP and IP.

Requirements

Applicable Products

Product series	Software version	Hardware version
Switch 5500	Release V03.02.04	All versions
Switch 5500G	Release V03.02.04	All versions
Switch 4500	Release V03.03.00	All versions
Switch 4210	Release V03.01.00	All versions

Configuration Procedure # Enable the information center.

<3Com> system-view

[3Com] info-center enable

#By default, the system outputs information of all modules to the console. Therefore, to obtain the system information of the ARP and IP modules, you need to disable the output of information of all modules to the console.

[3Com] undo info-center source default channel console

#Set the severity to informational, and the information source modules to ARP and IP.

[3Com] info-center console channel console

[3Com] info-center source arp channel console log level informationa l debug state off trap state off

[3Com] info-center source ip channel console log level informational debug state off trap state off

# Enable terminal display.

<3Com> terminal monitor <3Com> terminal logging

Complete Configuration #

info-center source ARP channel 0 trap state off