3
IP ADDRESS CONFIGURATION GUIDE
IP Address | If you want to manage a remote Ethernet switch through network management | |
Configuration Guide | or telnet, you need to configure an IP address for the remote switch and ensure | |
| that the local device and the remote switch are reachable to each other. | |
| A | |
| a switch is configured with one primary and four secondary IP addresses. | |
Network Diagram | Figure 6 Network diagram for IP address configuration | |
| 172.16.1.0/24 | Switch |
|
| |
Host B
172.16.1.2/24
172.16.1.1/24
172.16.2.1/24 sub
172 .16.2.2/24
Host A
172.16.2.0/24
Networking and As shown in the above figure, the port in VLAN 1 on Switch is connected to a LAN Configuration in which hosts belong to two network segments: 172.16.1.0/24 and Requirements 172.16.2.0/24. It is required to enable the hosts in the LAN to communicate with
external networks through Switch, and to enable the hosts in the two network segments to communicate with each other.
Applicable Products
Product series | Software version | Hardware version |
|
|
|
Switch 5500 | Release V03.02.04 | All versions |
Switch 5500G | Release V03.02.04 | All versions |
Switch 4500 | Release V03.03.00 | All versions |
|
|
|
