NEC 2400IMX Circuit No make busy request cancel, SW12 Recording from a tape recorder. Write, Mode

PA-4DATA (4DAT)

SWITCH	SWITCH NO.	SETTING	STANDARD	MEANING
NAME			SETTING
SW9 Note		E		Set to E while the circuit card is in use as an-
				nouncement equipment only.
		0		Designation of Circuit No. 0.
				The timer is 16-sec. mode.
		1		Designation of Circuit No. 1.
				The timer is 16-sec. mode.
		2		Designation of Circuit No. 2.
				The timer is 16-sec. mode.
		3		Designation of Circuit No. 3.
				The timer is 16-sec. mode.
		4		Designation of Circuits No. 0 and No. 1.
				The timer is 32-sec. mode.
		5		Designation of Circuits No. 2 and No. 3.
				The timer is 32-sec. mode.
		6		Designation of All Circuits.
				The timer is 60-sec. mode.
		F		Recording from a telephone set.
SW10		ON		Circuit No. 0 make busy request.
	0			Circuit No. 0 is designated during a recording.
		OFF	⋅	Circuit No. 0 make busy request cancel.
		ON		Circuit No. 1 make busy request.
	1			Circuit No. 1 is designated during a recording.
		OFF	⋅	Circuit No. 1 make busy request cancel.
		ON		Circuit No. 2 make busy request.
	2			Circuit No. 2 is designated during a recording.
		OFF	⋅	Circuit No. 2 make busy request cancel.
		ON		Circuit No. 3 make busy request.
	3			Circuit No. 3 is designated during a recording.
		OFF	⋅	Circuit No. 3 make busy request cancel.
SW12		UP		Recording from a tape recorder. (WRITE
(WR KEY)				mode)
		DOWN	⋅	Normal setting

Note: When this circuit card is being used as an external hold tone source, set 0, 4 or 6 by timer mode.

CHAPTER 4	NDA-24282 (E)
Page 140
Revision 1.0