NEC 2400IMX system manual NAP-215-114 Sheet 1/2

ACD SERVICE FEATURES FUNCTIONAL TEST PROCEDURES

			Announcement Trunk
NAP-215-114
Sheet 1/2
						ELC/DLC
Night Service								COT
		Split C				ELC/DLC
							ATI
START		D: ATT
							LC
	Use one of the following three methods to change			A
	into the night mode.				B
	(1) Automatic changeover into the night mode
	based on the ACD call control vector (Night
	Announcement setting using ACD CCV command).
	(2) Pressing the NIGHT key on the supervisory position of split C; as this display confirmation message
	Night Mode?, enter 1# to change over into the night mode.
	(3) Changeover into the night mode by means of operation at the MIS terminal of the supervisory posi-
	tion.
	Night Announcement

•Place a C.O. trunk call from station A to station B in the special night split. Station A hears the night announcement.

Apply the test procedure above to all splits.

Using the ACD CCV command, change the night services of the split and test each of the following ser- vices repeatedly.

Night Service Change

Using the ACD CCV command, change the night services of the split and test each of the following ser- vices.

Night Transfer to Station

•Place a C.O. trunk call from station A to station B. Call incoming at transfer destination station.

A

CHAPTER 6	NDA-24282 (E)
Page 328
Revision 1.0