NEC 2400IMX system manual Data Programming

Note 4

OFFICE DATA DESIGN

Data Programming

Step 1: ASYDL - ACD for Fusion Network. This data must be set for all nodes to be provided ACD service. SYS1, INDEX512: FPC number of the self-node (1-253)

*SYS1, INDEX865: FPC of the node providing IP. (When IVR is used, this data is necessary)

*SYS1, INDEX866: FPC of the node providing built-in ACDP.

Note 1: The same value (FPC) must be set to these indexes.

Note 2: Assign 0 for the node using ACD service in the self node only.

Step 2: ASYDN - SYS1, INDEX514: NDM usage

Step 3: Data programming procedures other than Steps 1, 2 are the same as those for the non-Fusion system (ACD stand-alone system). However, note which data is necessary for the node providing ACDP. The others are set to all Fusion nodes in which ACD trunks or ACD agents are installed.

Data required for the node that accommodates ACDP: ASYD - SYS1, INDEX2, b0:1=ACDP is used

SYS1, INDEX207, b0:1=ACDP0 is used

SYS1, INDEX207, b1:0/1=ACDP1 is not used/used ASYDL - SYS1, INDEX864, b0:1=Built-in ACDP is used

Note 3: PBX command data such as AKYD, AOKC, ASFC is set to all nodes in a Fusion Network.

Note 4: Not used in Internal ACD.

NDA-24282 (E)	CHAPTER 5
	Page 185
	Revision 1.0