NEC 2400IMX Did busy condition, ACD Announcement service 0/1=Out of service/In, Service. Note

ASYD: ASSIGNMENT OF SYSTEM DATA

Note 4: Terminal Control Facility Indirect is used for displays, LED functions, and chimes for ACD positions. The standard choice has both bit 1 and bit 2 set to “1”.

Note 5: Terminal Control Facility Direct is used for certain ACDP entries and displays from ACD positions.

Note 6: ASYD, System Data 1, index 59, bit 2 must also be set to a 1 for this feature to operate.

			System Data-1 Programming Sheet
SYSTEM	SYSTEM	DATA		BIT
			CORRESPONDING
	DATA
DATA		(DATA)		DATA
	INDEX					SYSTEM DATA CONTENTS
TYPE		00 ~ FF
	(INDEX)
			DATA
(SYS)		(Hex)			BIT
	0 ~ 255
			0/1
	59				b2	DID busy condition
						0/1 = No/Yes Note 1
	70		1		b6	ACD Announcement service 0/1=Out of service/In
						service. Note 2
					b4	Warning tone sent to the monitored position.
1	79					0/1=No/Yes Note 3
			0		b6	OAI/ACD Service Note 4
						0 = ACD In Service; 1 = ACD Out of Service
						Line of the LCD for static ACD messages (Break, Ready,
	80		0		b3	etc.) display.
						0/1=top line/second line

Note 1: Must be set to “1” for an “IF NOT QUEUED GO TO BUSY 11 step to return busy tone to a self-directing trunk (CCV function on DIDs etc.). This does not work with ringdown type trunks.

Note 2: When the announcement service is used in Fusion network, this data is set to nodes that accommodates the announcement trunk.

Note 3: Be sure to assign the data value “1” here (see Chapter 1, Section 1.3, “Precaution on Using the ACD Fea- tures”).

Note 4: When changing the value of this data bit to “0” (OAI/ACD Service Provided) from “1” (OAI/ACD Service Not Provided), system initialization must be executed.

CHAPTER 7 NDA-24282

Page 336

Revision 1.0