NEC 2400IMX 24A Trunk Trouble Report MIS ACD, Akyd Assign TRK Trbl function to feature key

TRUNK TROUBLE REPORT - MIS - ACD

T-24A TRUNK TROUBLE REPORT - MIS - ACD

GENERAL DESCRIPTION

This feature allows an agent to indicate a trouble condition affecting a trunk (e.g., poor transmission) which is encountered during a call. The system will log the agent’s position number and the number of the connected trunk. This information is printed out on the ACD MAT and provided to the MIS.

Although this feature is designed primarily to aid in the reporting of defective trunk circuits it does also report the connected party information even when the connected party is not a trunk such as in a station-to-station call.

Bad Call Notification

The trunk trouble report is logged to the MAT printer under the 6-H heading, Bad Call Notification. A special code within the 6-H report indicates the occurrence of the trunk trouble report. Additional codes used within the 6-H report are described in detail under Section 3.2.3, "Message Detail Data of System Message “6-H”"in Chapter 9.

OPERATING PROCEDURE

1.The operations at the ACD agent position and the supervisory position are as follows:

a.The agent is engaged in an ACD call.

b.The TRK TRBL key is pressed on the ACD agent position.

c.TROUBLE REPORTED is displayed on the position for four seconds and the trouble is reported to both the ACD MAT and the MIS terminal.

SERVICE CONDITIONS

There is no LED indication when the TRK TRBL key is pressed.

PROGRAMMING

AKYD - Assign TRK TRBL function to feature key.

NDA-24282 (E)	CHAPTER 5
	Page 297
	Revision 1.0