NEC 2400IMX system manual Ope, Err

PA-CC98 (ETHER)

4.Lamp Indications

The meaning of indication of each lamp on this circuit card is shown below.

LAMP	COLOR	MEANING OF INDICATION
OPE	Green	Remains lit while this circuit card is in operating status
	Red	When a fault has occurred within this circuit card, this lamp lights or flashes to-
ERR		gether with lamp S1, S2, or S3 so as to specify the contents of the fault
	Red
	Flash
S1	Green	Flashes when data frame has been sent out onto the LAN
	Flash
S2	Green	Lights when this circuit card is ready to operate
S3	Green	Remains lit while the power supply to this circuit card is on

5.Switch Setting

Each switch setting on this circuit card and its meaning are shown in the tables on the following pages.

The CC98 Internet address is set by using the AIPT MAT command. For ICS and IMX, Internet is set only by the AIPT command. For HDS (IMG) configurations, the AIPT command is used for setting the Internet address for software versions J04.7 and higher.

Contact NEC Personnel for Internet address settings in HDS software versions below J04.7.

Each CC98 card must have a unique MAC address. This MAC address allows each CC98 to be different from each other and different from any other LAN system. The MAC address is twelve digits in length. Switches SW0 and SW1 are used to set the lowest three digits. The remainder of the MAC address is fixed. The Internet address set by AIPT is used with the MAC address to allow the CC98 to connect to LAN net- works.

Note: If two or more CC98 cards are connected on the same LAN, each must have a unique MAC address.

CHAPTER 4	NDA-24282 (E)
Page 166
Revision 1.0