NEC 2400IMX system manual Akyd Assignment of Key Data for Dterm

AKYD: ASSIGNMENT OF KEY DATA FOR DTERM

AKYD: Assignment of Key Data for Dterm

1.Function

This command is used to assign, delete, and display the following key data corresponding to each line/ feature buttons of Dterm. For details of this command, refer to “AKYD” command in NEAX2400 IMX

Office Data Specification.

•Line Key Data

•Function Key Data

2.Precautions

1. Before assigning the key data for Dterm by this command, be sure to assign the station data (TN, STN, TEC = 12 (Dterm)) of the Dterm by ASDT command. The station number assigned by ASDT command

is referred to as “My Line”.

Note: The “My Line” corresponds to the physical port associated with the LENS of a DLC/ELC card.

2.By assigning another station line to a function button by this command, an incoming call terminated to a station line other than My Line can be answered or can be transferred to elsewhere as in the case of

the My Line. A station line other than My Line is referred to as a “Sub Line”. A “Sub Line” can be assigned not only to a Dterm but to any conventional telephone. In addition, the station data for My Line

and Sub Line must be assigned via the ASDT command before the key data is assigned. When the Sub Line and the My Line belong to different tenants, use the ATNR command and clear the “Tenant to Tenant Restriction”.

3.A Multi-Line key (the key for My Line and Sub Line) on the Dterm can be assigned as “Prime Line”. If

the Prime Line is not assigned, the My Line will serves as the Prime Line. When the user goes off-hook, the Prime Line is automatically connected to the Dterm.

4.A virtual line can be assigned as a Sub Line of the Dterm. The virtual line can be used the same way as the My Line for outgoing calls and other service operations.

Note: Virtual Line — A virtual LENS exists only in memory, but does not exist physically. Data can be assigned but no hardware is provided for it; ex. LENS = 000311. The virtual LENS is assigned station data using the ASDT command in the same way as for on ordinary line. (The telephone class is TEC = 18: Virtual Line)

5.When this command is used, the DLC/ELC card must be reinitialized (MB switch UP-DOWN).

6.Key data programmed in this command must be set to all nodes to be provided ACD service for Fusion network.

Note: Use Command ADKS for Series E Dterm.

CHAPTER 7 NDA-24282

Page 348

Revision 1.0