NEC 2400IMX system manual Algnn Assignment of Telephone Number Data for NDM, General

ALGNN: Assignment of Telephone Number Data for NDM

ALGNN: Assignment of Telephone Number Data for NDM

1.General

This command assigns the individual attendant identification number for Fusion service. The data assigned by this command is written in Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node (LN).

2.Precautions

1.The applicable tenant number (TN) range is designated by the ASYDN command, SYS 1, INDEX 8. If the numbering plan is common for all tenants (ASYDN, SYS1, INDEX 800, bit0 = 1), assign TN parameter as “1” for all tenants.

2.The system data assignment (ASYDN, SYS 1, INDEX 514, bit1 = 1) is needed to provide the Network Data Memory (NDM).

3.Before assigning this command, ANPDN/ASPAN commands are required for the numbering plan of the Telephone Number (TELN).

4.A unique Telephone Number (TELN) should be given within a User Group Number (UGN).

5.For more detail, see the NEAX2400 IMX Fusion Network System Manual.

3.Data Entry Instructions

UGN

1 = User Group Number 1 (Fixed)

TELN

Assign Telephone Number (Unique TELN should be given within a UGN)

USER GROUP	TELEPHONE STATION NUMBER (TELN)							REMARKS
NUMBER (UGN)		MAX. 16 DIGITS
1			4	0	0	0	0
1			4	0	0	0	1
1			4	0	0	0	2

Note: All monitored (Pilot) numbers must be added here and in AMNON for Fusion Network.

CHAPTER 7	NDA-24282 (E)
Page 370
Revision 1.0