NEC 2400IMX =ACDP is used, Assign 01 Hex Note, ACD in Service Fixed Data, = No/Yes Note

ASYD: ASSIGNMENT OF SYSTEM DATA

System Data-1 Programming Sheet

Note: This Data Programming Sheet is only for the data to be set in the ACD System. Be sure to use this Data Programming Sheet together with the Data Programming Sheet for “ASYD” command described in the NEAX2400 IMX Office Data Specification.

	SYSTEM			BIT
SYSTEM		DATA	CORRESPONDING
DATA	DATA	(DATA)		DATA
	INDEX						SYSTEM DATA CONTENTS
TYPE		00 ~ FF
	(INDEX)
(SYS)		(Hex)	DATA
	0 ~ 511				BIT
			0/1
	2	01	1		b0	1=ACDP is used
						(Assign 01 Hex) Note 1
	27		0		b4	ACD in Service (Fixed Data)
						0 = In service; 1 = Out of service
	31	04	1		b2	Note 2
	42				b2	System Message “5-Q” is output.
						0/1 = No/Yes Note 3
					b0	Traffic Measurement Indication
						0/1 = CCS Indication/Erlang Indication
1			1		b1		b2 b1
						TCFI timer: 0 0 = 2 sec. interval
						Note 4	1 1 = Application Dependent
			1		b2		(Standard)
							0 1 = 4 sec. interval
	47						1 0 = 8 sec. interval
			0		b3	0 = Display last number for TCFD
						1 = Display message Note 5
					b4	ACD Busy Tone Control
						0/1 = No/Yes Note 6
					b7	Traffic Measurement for Terminal and Route Traffic
						0/1 = Out/In Service

Note 1: For ACD system to be activated through Fusion network, this data is programmed in the node providing ACDP only. Other system data than INDEX2 must be set to all nodes to be provided ACD trunk-Fusion within Fusion network.

Note 2: When changing this index from 02 (normal setting for non- OAI/ACD system) to 04, you must back up DM to the HDD of the system.

Note 3: Valid since the PBX software Series 7300 and the ACD software R1.

NDA-24282CHAPTER 7

Page 335

Revision 1.0