NEC 2400IMX system manual Set/Reset when idle

SYSTEM OPERATIONS

2.4 BREAK MODE

When it is required to leave the position unattended for a lunch or similar break, use the following procedure to activate the Break mode in which the ACD call handling services can be interrupted temporarily.

(a) Set/reset during Communication with ACD Call

START

On handling an ACD call, press the BREAK key.

The lamp lights and BREAK PENDING is displayed.

Press the RELEASE key.

ON BREAK is displayed, indicating Break mode.

(Break)

Press the BREAK key.

The lamp goes off, and ON BREAK OVER XX:XX (time spent on break in minutes and seconds) is displayed. Note 1

Break mode ends, and the position becomes idle and available for receiving the next ACD call (READY is displayed).

END

(b) Set/Reset when idle

START

Press the BREAK key.

The lamp lights and ON BREAK is displayed

(Break)

Press the BREAK key.

The lamp goes off, and BREAK OVER XX:XX (time spent on break in minutes and seconds) is displayed. Note 1

Break mode ends, and the position becomes idle and available for receiving the next ACD call (READY is displayed).

END

Note 1: The period of time in break mode is displayed for 99 minutes and 59 seconds. When 99 min. and 59 sec. passes, the part of indicating “Minute” is displayed as “**”.

CHAPTER 8 NDA-24282

Page 430

Revision 1.0