NEC 2400IMX Asyd SYS1, Asydl SYS1 INDEX512, INDEX513, INDEX864, INDEX865, INDEX866, INDEX533

Note 2

INSTALLATION

4.2 BASIC DATA ASSIGNMENT FOR START-UP

STEP 1 : Change the system data written in DM.

ASYD SYS1

INDEX2 - b0=1 (ACDP mounted) INDEX31 - b0~b3: CM mounting capacity

Assign Normally “06”. Note 1 INDEX79 - b6=0 (ACD service is effective) Note 1 INDEX207 - b0=1 (ACDP in system0 is used)

b1: ACDP in system1 0/1=Not used/Used

INDEX241 - b2=1 (call event process) Note 1

Note 1: When the ACD service is activated via FCCS, this data must be set to all nodes providing ACD service (Not just the node accommodating the ACDP).

STEP 2 : Assign the system data written in LDM as shown below.

ASYDL SYS1
INDEX512:	FPC of the self-node
INDEX513:	01 Hex (LDM usage)
INDEX515~518	b0~b7:	IP address (Hex) for PBX over external LAN	Note 2
INDEX519~522	b0~b7:	Subnet Mask (Hex) for PBX over external LAN	Note 2
INDEX523~526	b0~b7:	Default Gateway Address for External LAN

(This data is required when the Host is connected via gateway)

INDEX864 - b0=1 (Built-in ACDP is provided)

INDEX864	b1:	Output the system message (4-R) when TCP-IP is normally disconnected.
		0/1 = Effective/Ineffective	Note 3
	b2:	0/1 = “Agent Anywhere” Out of Service/In Service
	b3:	0/1 = Multiple ACDPs Not Available/Available
INDEX865:	FPC of Node Providing IP.
INDEX866:	FPC of Node Providing ACDP.

Note 2: If the MAT or SMDR has been connected with external LAN already, this data assignment is not necessary.

STEP 3 : Assign the System data written in NDM.

This data is necessary when using “AGENT ANYWHERE” (Available since the PBX software Series 7300.)

ASYDN SYS1
INDEX514-	NDM usage
INDEX533-	FPC of the node that provides VNDM

STEP 4 : Check the station-to-station connection and confirm no fault status occurs or system messages are output (such as cable connection fault, LCD display fault, memory alarm fault, abnormal interrupt, etc.).

STEP 5 : Program the ACD office data. Also, program the Fusion data to make ACD service effective through Fusion network, if necessary. Refer to Chapter 5, “Office Data Design”.

STEP 6 : Save the DM, ACD data memory into the HDD by using MEM_HDD.

CHAPTER 3 NDA-24282

Page 36

Revision 1.0