8 Printer Environment Settings
This chapter describes how to set up the printing environment for the machine. Some models require a Printer Kit to use the print feature on the machine.
The following information is provided:
Windows TCP/IP – page 233
NetWare – page 236
UNIX TCP/IP – page 240
EtherTalk – page 257
Microsoft Networking – page 259
TCP/IP (LPD or Port9100) – page 263
USB Port – page 267
IPP (Internet Printing Protocol) – page 270
Windows TCP/IP
This section explains how to set up the machine to operate in a Windows TCP/IP environment. The following information is provided:
Quick Network Setup (DHCP) – page 233
Quick Network Setup (Static IP) – page 234
Quick Network Setup (DHCP)
Prerequisites for Quick Network Setup Using TCP/IP
1.Confirm that an existing operational network utilizing TCP/IP is available.
2.Confirm that the Ethernet cable is plugged into the multifunction machine and into an operational Ethernet port on the network.
NOTE: The Ethernet cable is an RJ45 type and is not supplied by Xerox.
Configuring an IP Address via DHCP
On startup, the multifunction device defaults to DHCP to obtain its network configurations. A DHCP server delivers an IP address, as well as other configuration settings to the machine. If you use a DHCP server to allocate an IP address to the machine, then proceed as follows:
Procedure for Quick Network Setup Using TCP/IP
1.Power on the machine.
2.Wait a minute or so while the machine negotiates an IP address.
3.Print the Configuration Report.
1)Select the <Machine Status> button on the machine.
2)On the [Machine Information] screen, select [Print Reports].
3)Select [Printer Reports].
233
