Xerox 5225A, 5230A manual Code Description and Remedy

	Fault Codes
Code	Description and Remedy
116-720	A print error occurred due to insufficient memory. Close unused ports or delete
	unnecessary data.
116-740	A print error occurred. A parameter value is greater than the limit value. Check
	the print settings.
116-749	The print job was stopped, because the specified font was not found. Install the
	font, or enable the font substitution setting in the print driver.
116-752	The description in the PDF print job ticket has a problem. Repeat the same
	procedure. Contact the Xerox Welcome Center if the problem persists.
116-771	The parameter values were corrected, because the machine encountered a
116-772	problem when printing the data. If the received image is incomplete or
116-773	damaged, ask the sender to check the image and to resend the data. When
116-774	Internet Fax forwarding is enabled, check with the recipient if the image has no
116-775	problem.
116-776
116-777
116-778
116-780	The document attached to the received e-mail has a problem. Check the
	attached document.
116-790	• If the machine did not staple any print sets, check that the specified stapling
	position is appropriate, and then try again.
	• If a user stops a confidential Fax or Internet Fax print job while the machine is
	printing the data of the job, the machine will not staple the first print set.
	Manually staple the first set in that case.
123-400	The machine has detected a software-related problem. Switch off the machine,
	and then switch it on again. Contact the Xerox Welcome Center if the problem
	persists.
124-328	A punch unit was not found. Specify a punch unit following the screen
	instructions.
124-701	Due to a malfunction in the specified tray (left side tray), the output destination
	was changed to the center tray. Contact the Xerox Welcome Center. The other
	trays are available.
124-702	Due to a malfunction in the specified tray (finisher tray), the output destination
	was changed to the center tray. Contact the Xerox Welcome Center. The other
	trays are available.
124-705	The punch setting was cancelled.
	Check the punch position, and try again.
124-706	The folding setting was cancelled.
	Check the folding setting, and try again.
124-708	The output destination was changed to the center tray. Check if the specified
	size paper is loaded in a paper tray.
124-709	The document exceeded the maximum number of pages that can be stapled.
	Reduce the number of pages, or cancel the stapling setting, then try printing
	again.

427