
|
| Fault Codes |
|
|
|
| Code | Description and Remedy |
|
|
|
|
|
|
| Unable to process PCL print data due to insufficient print page buffer memory. | |
|
| Increase the print page buffer. |
|
|
|
| The PCL print data contains an invalid command. Check the print data, and then | |
|
| try again. |
|
|
|
| A print error occurred. The Auto Tray Switching setting conflicts with the Paper | |
|
| Type Priority settings. When the Auto Tray Switching feature is enabled, select |
|
| an option other than [Auto Paper Off] for trays on the [Paper Type Priority] |
|
| screen. |
|
|
|
| The specified staple position is not supported. Change the staple position, and | |
|
| try again. |
|
|
|
| The specified | |
|
| position, and try again. |
|
|
|
| The specified staple and | |
|
|
|
| A scanned document saved in a mailbox could not be converted to fax data | |
|
| using the job flow sheet. Send the document not by using the Job Flow Sheets |
|
| service, but by using Fax service. |
|
|
|
| The printer language was not selected automatically. The probable causes are | |
|
| as follows: |
|
| • PostScript data was sent to the machine, but the PostScript Kit was not |
|
| installed on the machine. |
|
| • PDF data was sent directly to the machine using the lpr command, but the |
|
| HDD was defective. Contact the Xerox Welcome Center. |
|
| • PCL data was sent to the machine, but the optional emulation kit was not |
|
| installed on the machine. |
|
|
|
| The Save to Mailbox job was cancelled, because there was no data for the job. | |
|
| Check if the document is blank. |
|
|
|
| The TIFF file contains unsupported tags. Check the print data. | |
|
|
|
| The TIFF file could not be printed, because the resolution of the TIFF file was | |
|
| too high. Lower the resolution of the TIFF file, and try again. |
|
|
|
| The print job was interrupted. Try printing the data again. | |
|
|
|
| The form specified in the emulation setting is not registered in the host | |
|
| computer. Resend the form data. |
|
|
|
| The IP address after the @ character could not be obtained. Enter the | |
|
| address correctly. |
|
| Or, the DNS Internet address after the @ character could not be resolved. Set |
|
| the DNS server address correctly. |
|
|
|
| Printing a simple transmission report failed. Set the | |
|
| the sender’s end to [SMTP]. |
|
|
|
| An attempt was made to print a job template while it was being updated. Wait a | |
|
| while, and then try printing the template again. |
|
|
|
| A lock directory was not created. | |
|
| • Check that there is space on the target disk. |
|
| • Check the access permissions. |
|
| • Delete any existing lock directory. |
|
|
|
| The lock directory was not deleted. Delete the lock directory. | |
|
|
|
399