TCP/IP (LPD or Port9100)

Computer Setup

Install the print driver on the client computer. Refer to the HTML document on the PCL Print Driver CD-ROM.

Test Print

Make sure the machine has been installed on the network correctly by submitting a test print from each client computer. Perform the following steps.

1.Open a document on a client computer.

2.Select the machine as the printer.

3.Print the document on the machine and verify that it prints correctly.

4.Make sure that the print driver is installed on every computer that will be sending jobs to the machine.

5.Repeat the test for all computers that will be sending jobs to the machine.

The installation process is now complete.

If the test print fails, refer to Problem Solving on page 349.

TCP/IP (LPD or Port9100)

This section explains how to set up the machine to print from a Windows computer through LPD or Port9100. The following information is provided:

Information Checklist – page 263

TCP/IP (LPD or Port9100) Environments – page 264

TCP/IP (LPD or Port9100) Installation – page 264

Installation Procedure – page 264

Network Communication Setup – page 265

Computer Setup – page 265

Test Print – page 265

Information Checklist

Before starting these procedures, make sure that the following items are available or have been performed.

 

Item

By

 

 

 

 

An existing operational network utilizing TCP/IP is required. These

Customer

procedures are not designed to install a network.

 

 

 

Obtain and record the following information:

Customer

IP address

 

Gateway address

 

• Subnet mask (for IPv4) / Prefix (for IPv6)

 

Host name

 

 

 

Test the machine to make sure that it is fully installed and functioning

Customer

correctly.

 

 

 

Install the print driver.

Customer

 

 

 

263

Page 263
Image 263
Xerox 5225A, 5230A manual TCP/IP LPD or Port9100, Computer Setup