15 Problem Solving

Stapler Faults

The following describes stapler troubles when the Finisher (optional) is installed.

Follow the procedures on the following pages when copies are not stapled or when staples are bent. Contact your Xerox Welcome Center if the problem persists after you have tried the following solutions.

Unstapled

Bent staple

If staples are stapled on the copies in the manner shown in the figures below, contact your Xerox Welcome Center.

One side of staple rising up

Flattened staple

Staple bent in reverse direction

Entire staple rising up

Staple rising up with

center pressed in

362

Page 362
Image 362
Xerox 5230A, 5225A manual Stapler Faults