
NetWare
Target computers
The NetWare versions and NetWare client computers require the following environments.
NetWare versions
A
NetWare client computers
A
NOTE: When using the LPD port by Novell Distributed Print Services (NDPS), activate the LPD port on the machine and set the IP address.
IPX/SPX frame types
The machine supports the following Ethernet interfaces.
•
•
The machine supports the following frame types.
•Ethernet II specification
•IEEE802.3 specification
•IEEE802.3/802.2 specification
•IEEE802.3/802.2/SNAP specification
The machine sends out packets of each frame type on the connected network. It automatically uses the frame type which corresponds to the first response. However, if more than one protocol is running simultaneously on the same network, the machine will use the same frame type as used by the NetWare server.
NOTE: Some network components, such as the hub, may not support automatic frame type setup. If the data link indicator light of the port does not light up, match the IPX/SPX setting of the frame type of the machine, to the frame type of the file server.
NetWare Installation
This section describes the installation procedures to use the machine in a NetWare environment.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
Enable the NetWare port. When using IPX:
Set the NetWare port to [Enabled] using the touch screen or CentreWare Internet Services.
When using TCP/IP:
Set the NetWare port to [Enabled] using the touch screen or CentreWare Internet Services. Set the IP address on the control panel or CentreWare Internet Services.
For more information, refer to Network Communication Setup on page 238.
237