8 Printer Environment Settings

NetWare Setup

For more information, refer to NetWare Setup on page 239.

Computer Setup

For more information, refer to Computer Setup on page 239.

Test Print

For more information, refer to Test Print on page 239.

Network Communication Setup

Use this procedure to set up the network communication parameters of the machine. At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP network.

NOTE: Some of the configuration options for this protocol are only available from CentreWare Internet Services. Refer to CentreWare Internet Services on page 149.

First, enable the NetWare port.

1.Connect the machine to the network.

2.Press the <Log In/Out> button on the control panel, and then type the System Administrator login ID to enter the System Administration mode.

NOTE: The passcode may also be required depending on the machine configuration.

3.Press the <Machine Status> button on the control panel, and then select the [Tools] tab on the screen.

4.Select [System Settings] in the menu at the left side of the screen.

5.Select [Connectivity & Network Setup] in the [Group] menu.

6.Select [Port Settings] in the [Features] menu.

7.Select [NetWare], and then [Change Settings].

8.Select [Port Status], and then [Change Settings].

9.Select [Enabled], and then [Save].

Next, establish TCP/IP if you use an IP Address for the NetWare network.

1.Select [Connectivity & Network Setup] in the [Group] menu, and then select [Protocol Settings] in the [Features] menu.

2.Under [TCP/IP - IP Mode], select [IPv4 Mode] or [Dual Stack].

NOTE: [IPv6 Mode] is not available for NetWare settings.

3.Select [IPv4 - IP Address Resolution], and then [Change Settings].

4.Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], [DHCP/Autonet], and [STATIC], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server (WINS) server.

If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol settings. Otherwise, proceed to step 11.

5.Select [IPv4 - IP Address], and then [Change Settings].

238

Page 238
Image 238
Xerox 5230A, 5225A manual Network Communication Setup, NetWare Setup, Computer Setup, Test Print