Internet Fax Installation
Network Communication Setup
NOTE: Some of the configuration options for this protocol are only available from CentreWare Internet Services. Refer to CentreWare Internet Services on page 149.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP network.
Initially, activate the port.
1.Connect the machine to the network.
2.Press the <Log In/Out> button on the control panel, and then type the System Administrator login ID to enter the System Administration mode.
NOTE: The passcode may also be required depending on the machine configuration.
3.Press the <Machine Status> button on the control panel, and then select the [Tools] tab on the screen.
4.Select [System Settings] in the menu at the left side of the screen.
5.Select [Connectivity & Network Setup] in the [Group] menu.
6.Select [Port Settings] in the [Features] menu.
7.Select [Receive
8.Select [Port Status] and then [Change Settings].
9.Select [Enabled] and then [Save].
10.On the [Port Settings] screen, select [Send
11.Select [Port Status] and then [Change Settings].
12.Select [Enabled] and then [Save].
Next, establish TCP/IP.
1.Select [Connectivity & Network Setup] in the [Group] menu, and then select [Protocol Settings] in the [Features] menu.
2.Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].
When [IPv4 Mode] or [Dual Stack] is selected in step 2
3.Select [IPv4 - IP Address Resolution], and then [Change Settings].
4.Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], [DHCP/Autonet], and [STATIC], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server (WINS) server.
If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol settings. Otherwise, proceed to step 11.
5.Select [IPv4 - IP Address], and then [Change Settings].
6.Use the keypad on the screen to enter an IP address for the machine in the format “xxx.xxx.xxx.xxx”. When you have finished entering all values, select [Save].
7.Select [IPv4 – Subnet Mask], and then [Change Settings].
8.Using the same method as in step 6, enter a subnet mask.
9.Select [IPv4 – Gateway Address], and then [Change Settings].
297
