Lucent Technologies Release 6 manual Connect to the System, Rear Panels on Management Terminals

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

3Install Management Terminal and Activate System

Install Management Terminal Page 3-4

21

1

P2-DTEP1-DCE

	P1-DCE	P2-DTE
PAR	AUX PORT	MAIN PORT

	COM2	PARALLEL	COM1
				0069_0 RBP 072296
Figure Notes
1.	Rear Panel of 715 BCS Terminal		5.	Modular Keyboard Jack
2.	6-Pin Mini DIN Connector		6.	COM 1 Port
3.	Rear Panel of 2900/715 BCS Terminal		7.	Rear Panel of 715 BCS-2
4.	P2-DTE Port			Terminal

Figure 3-2. Rear Panels on Management Terminals

Connect to the System

1.Route the 25-pin DTE cable from the terminal to the rear of the system.

2.For Release 6si, connect the cable to the TERM connector. See Figure

3-3. For Release 6r, connect the cable to the Terminal Active connector. See Figure 3-4.

3.Plug the AC power cord into the AC receptacle on the terminal. Plug the opposite end of the power cord to the AC receptacle located at the bottom rear of the cabinet, or into the selected AC receptacle.

4.Set the terminal power switch ON.