Lucent Technologies Release 6 manual Install cables from the cabinet to the MDF as required

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add PRI Over PACCON to R6si Page 5-126

Since the packet bus is required with PRI Over PACCON, the TN778 Packet Control circuit pack should be added first. If the system is not equipped with a packet bus see ‘Add‘ Packet Bus to R6si’’ on page 5-113.

If EPNs reside in the system, replace every TN776 EI circuit pack with a TN570 EI to provide packet-based communication between the PPN and each EPN.

2.Remove an existing TN756 Tone Detector/Generator circuit pack and install the TN768, TN780, or TN419B Tone-Clock circuit pack in assigned carrier slot, if required.

3.Determine port assignment of port circuit packs to be added.

4.Install the TN464 circuit pack in assigned carrier slot (as required). For example:

Port Number	3	B	02	01
	Cabinet	Carrier	Slot	Circuit
	(Port Network)

5.Install the TN748B (or the non-United States TN420B) Tone Detector circuit packs, as required.

Install Cables

1. Install cables from the cabinet to the MDF as required.

Power Up System

1.At each EPN, set the main circuit breaker to ON.

2.At the PPN, set the main circuit breaker to ON.

3.The system performs a level 4 reboot, loading the system translations from the translation card or tape. Rebooting takes several minutes.

4.After the system reboot is finished and all trouble is cleared, verify the EMERGENCY TRANSFER CONTROL switch is set to AUTO. This restores the system to the normal mode.