Lucent Technologies Release 6 manual Add Circuit Packs, Cabinet Carrier Slot Circuit Port Network

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add ISDN—BRI Page 5-122

Add Circuit Packs

1.Determine port assignment of circuit packs to be added.

2.Install the appropriate circuit pack in assigned cabinet slot (as required). For example:

Port Number	3	B	02	01
	Cabinet	Carrier	Slot	Circuit
	(Port Network)

3.The TN778 Packet Control circuit pack and the TN556 or TN2198 ISDN BRI circuit pack are required. Add the TN778 Packet Control circuit pack first. If an EPN is present, a TN570 Expansion Interface circuit pack is required.

4.The packet bus is required with BRI. If the system is not equipped with a packet bus see ‘Add‘ Packet Bus to R6si’’ on page 5-113.

Install Cables

1.Install cables from cabinet to the MDF as required.

NOTE:

BRI requires a 12-port backplane cable terminator (breakout connector). Connect this terminator to the 25-pair cable. This is different from the 8-port connector used for DCP.

Power Up System

1.At each EPN, set the main circuit breaker to ON.

2.At the PPN, set the main circuit breaker to ON.

3.The system performs a level 4 reboot, loading the system translations from the translation card or tape. Rebooting takes several minutes.

4.After the system reboot is finished and all trouble is cleared, verify the EMERGENCY TRANSFER CONTROL switch is set to AUTO. This restores the system to the normal mode.

Enter Added Translations

1.Administer the required translation data using the forms listed under 7500D voice terminals and 8500 voice terminals in DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description.