Lucent Technologies Release 6 Install Intercabinet Shielded Ducts, Figure C-3. Dust Cover Removal

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998
C Cable Ductwork
	Page C-7

Install Intercabinet Shielded Ducts

1.Loosen (do not remove) the four bolts holding the dust cover to the cable access hole in the top of the cabinet.

plate KLC 071696

Figure C-3. Dust Cover Removal

2.Remove the dust cover by sliding it in the direction shown by the arrow in Figure C-3. Move the dust cover until it clears the bolts.

3.Set the cabinet riser (“A” in Figure C-4) with its base in place of the dust cover just removed. The four slots in its base should be just behind the bolts and the heads of the two middle bolts should have cleared the holes provided for them. Push the riser forward to seat the bolts in the four slots in the base of the riser. Then tighten the bolts.