Lucent Technologies Release 6 manual Administer Fiber Links on Simplex Systems

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

3Install Management Terminal and Activate System

Administer Fiber Links (Release 6r Only) Page 3-24

Administer Fiber Links on Simplex Systems

1.Administer the TN570 Expansion Interface and the TN574 or TN1654 DS1 Converter circuit packs. Enter the change circuit packs command and press Enter. See Screen 3-9.

Screen 3-9. Circuit Packs Form

2.Scroll through the pages on the form until the carrier containing the new circuit packs displays. Enter the circuit packs into the appropriate slot locations on the form. Press Enter when finished.

3.Enter the list fiber command. All administered fiber connections display.

4.If a previously used fiber link is to be reused, enter the add fiber

< number> command. If this is a new fiber link, enter the add fiber next command. The Fiber Link Administration screen appears. Use this form to administer fiber links, each of which is identified by a fiber number.

5.Enter y or n in the field Is one endpoint remoted via DS1 Converter complex? and press Enter.

6.Enter the location of the TN570 and the TN574 or TN1654 circuit pack for both ENDPOINT-1 and ENDPOINT-2.

7.Scroll to page 2 of the form. Enter y as applicable, in each Facility Installed? field (A, B, C, and D).

8.In the Bit Rate: field, enter either 1.544 (T1) or 2.048 (E1).

9.Enter the idle code in the Idle Code MSB (1) . . . . LSB (8): field. The default value is 11101000. It is recommended that the default value be used unless it becomes absolutely necessary to change it. The “MSB” means Most Significant Bit, the “LSB” means Least Significant Bit.