Lucent Technologies Release 6 manual Enable Customer Options

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add PRI Over PACCON to R6si Page 5-129

2.The system performs a reset level 4 reboot, loading translations from the translation card. Rebooting requires 8 to 11 minutes.

3.Login at the login: prompt on the management terminal, and set the time to ensure that the system is booted properly.

4.Enter list configuration software-version and press Enter to compare the version number of the software program (displayed on the terminal) with the TN790 version number (written on a label on the TN790’s faceplate). If the version numbers are not the same, change the version number on the TN790 label so that they agree.

NOTE:

Certain forms have changed for Release 6. Upgraded translations may appear on a different form, fields may shift within a form, or the names assigned to particular fields may change. Refer to DEFINITY Enterprise Communications Server Release 6 Transition Reference, and DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description, and make the necessary changes.

Enable Customer Options

1.Enter change system-parameters customer-options and press Enter.

2.Use these forms to verify the customer options are properly set.

NOTE:

If the customer was using Supplementary Services Protocol “b” or “d” on an ISDN-PRI trunk group before the upgrade, set the Basic Call Setup field to y.

Resolve Alarms

1.Examine the alarm log. Resolve any alarms that may exist using DEFINITY Enterprise Communications Server Release 6 Maintenance for R6r.