Lucent Technologies Release 6 manual Add Additional TN750C Circuit Packs

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add Multiple Announcement Page 5-109

Add Additional TN750C Circuit Packs

1.Install the TN750C into a vacant slot in a carrier.

NOTE:

Any carrier is acceptable since power holdover is not a concern.

2.Administer a new data module on the TN750C circuit pack, as described in DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description.

3.Administer new announcements to that TN750C slot by executing the change announcements command and filling in the “designated board location” field for the circuit pack’s location.

4.Record the announcements, as described in DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description.

5.Wait until the announcements copy from voice RAM to the on-board flash memory (the yellow LED on the TN750C starts and then stops flashing). This may take about 10 minutes.

Move a Single Announcement from 1

Announcement Circuit Pack to Another

1.Execute the change announcements command to change the circuit pack locations of a particular announcement. You may also change the compression rate at this time.

2.Rerecord the announcement, as described in DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description.