Lucent Technologies Release 6 manual Install cables from cabinet to the MDF as required

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add CallVisor ASAI Page 5-119

Install Cables

1. Install cables from cabinet to the MDF as required.

Power Up System

If the packet bus was added:

1.At each EPN, set the main circuit breaker to ON.

2.At the PPN, set the main circuit breaker to ON.

3.The system performs a level 4 reboot, loading the system translations from the translation card or tape. Rebooting takes several minutes.

4.After all trouble is cleared, verify the EMERGENCY TRANSFER CONTROL switch is set to AUTO. This restores the system to the normal mode.

Enter Added Translations

1.Administer the required translation data using the forms listed under “Adjunct/Switch Applications Interface (ASAI)” in DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description.

Resolve Alarms

1.Examine the alarm log. Resolve any alarms that may exist using DEFINITY Enterprise Communications Server Release 6 Maintenance R6r.

Contact INADS to Enable Customer Options and

Verify Alarm Origination

1.Be sure the system is part of the existing INADS database by calling the INADS Database Administrator at the Technical Service Center (TSC). Verify that INADS can dial into the system and that the system can dial out to INADS.

As part of the system registration process, the INADS Database Administrator enables Alarm Origination and enables customer options.

! CAUTION:

If you do not enable Alarm Origination when the customer has purchased a services contract, the system cannot report any alarm to the TSC automatically, causing the TSC to be unable to fulfill the services contract.