Lucent Technologies Release 6 manual External Modem Option Settings

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998
B Option Switch Settings
External Modem Option Settings	Page B-2

External Modem Option Settings

The COMSPHERE 3700, 3800, and 3900 series (recommended) external modems may require option switch settings. Refer to the documentation that accompanies each modem to set the options.

NOTE:

Alocally obtained, type-approved external modem may be used. Contact your Lucent Technologies representative for more information.

The Release 6 systems operate with the COMSPHERE modems set to the factory default settings. The modem settings and descriptions are listed in Table B-1.

Table B-1. Modem Fields

Modem
Connection	Description
Modem Name	This field is 20 characters long and permits alphanumeric characters to
	provide a unique qualifier for a given modem (such as INTEL).
RTS/CTS	Informs the modem that communication with the data source UART is
Enabled	driven with RTS/CTS flow control. The field name has a default of \Q3 in a
	field 6 characters long. This field is not case sensitive. Default is upper
	case.
Asynchronous	Configures modem as an asynchronous communications device. The
Data Mode	field name has a default value of &M0&Q0 in a field 8 characters long.
	This field is not case sensitive. Default is upper case.
DTE	Adjusts the speed of the data source (DTE) UART to the outgoing
Auto-Data	(modem-to-modem) data rate. At maximum, this speed is 9600 baud. It is
Speed	not desirable to have the serial data fill the modem buffer faster than the
	outgoing data rate, since data compression is disabled. The field name
	has a blank default value in a field of 6 characters. The Lucent products
	use the command S90=1 to enable this functionality while the Intel
	product uses the command \J1 to enable similar functionality. This field is
	not case sensitive. Default is upper case.
Disable Data	Turns off the default data compression algorithms in use by most
Compression	modems. The field has a blank field of 6 characters as default. The AT
	commands that control this are supported by similar commands;
	however, these commands do not operate in the same manner. The Intel
	modems require “H0%C0” to disable V.42bis & MNP Class 5 data
	compression algorithms. The Paradyne products only use %C0 to disable
	both algorithms. This field is not case sensitive. Default is upper case.

Continued on next page