Lucent Technologies Release 6 manual Change Site-Data, Change Cabinet

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

3Install Management Terminal and Activate System

Administer System Configurations (Release 6r) Page 3-21

Change Site-Data

This form initializes the building, floor, and color data to make them available later in help messages that refer to site information.

1.At the Command: prompt, enter the change site-datacommand. The first of 3 pages of site data appears:

2.Enter optional names for the buildings or offices served by the system.

3.Access the remaining site-data pages and fill them in appropriately.

Change Cabinet 1

1.Enter change cabinet 1. A screen similar to Screen 3-7 appears.

2.Fill in the blanks as required by the location and nature of the cabinet. If the system is critical reliability, verify the B field is set to the processor option, the D field is set to the dup-sw-node option, and the E field is set to the switch-node option.

Screen 3-7. Typical Change Cabinet 1 Form