Lucent Technologies Release 6 manual Activate the System, Set Up Management Terminal

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

3Install Management Terminal and Activate System

Activate the System Page 3-7

Set Up Management Terminal

Each management terminal requires a different setup procedure. Refer to the installation and usage instructions packed with the management terminal.

Install Management Applications

The PC-based Management Applications are installed according to the complete installation instructions provided in Management Applications Operations, 585-229-202.

Activate the System

Instructions are provided to activate Release 6 and later systems. To activate a

G3V4 and earlier system, refer to DEFINITY Communications System Generic 3

Installation and Test, 555-230-104.

NOTE:

To prevent unnecessary trouble tickets, do not enable the system alarms (Alarm Origination feature) until all installation and administration procedures are completed.

! CAUTION:

It may be necessary to reseat circuit packs. To prevent damage from static electricity, always wear an Electromagnetic Compatibility (EMC) wrist strap (comcode 900698226) when handling all system components.

Install Translation Card (Release 6si in MCC

Cabinet)

If a Release 6r system is installed, skip this section.

1.Insert the translation card into the TN777B Network Control circuit pack in the direction indicated by the arrow on the label.

Power Up the System

AC-Powered System

1.Set the circuit breakers on the AC power panel to ON. If the system is high or critical reliability, power-up the EPN cabinet first, then the PPN cabinet. Always power up the PPN cabinet last.

2.Set the cabinet circuit breakers to ON. This starts the system initialization and test. All red LEDs on the circuit packs go on and then off.

3.Skip to ‘Verify‘ Messages on Terminal’’.