Lucent Technologies Release 6 manual Patch Cord/Jumper Installation Administration

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998
2 Install Telecommunications Cabling
Patch Cord/Jumper Installation and Administration	Page 2-45

r758422i LJK 050996

Figure Notes:

1.Write Floor or Building Identification on Label

2.Cabinet

3.Carrier

4.Slot

5.Information Outlet

6.Site/Satellite Closet

7.Tie Circuit

8.Floor

9.Building

Figure 2-24. Label Graphic Symbols and Nomenclature

Each 110-type label identifies 2 rows on the 110-type terminal block. The upper half identifies the row above it and the lower half identifies the row below it. The labels are inserted into the clear plastic designation strips furnished with the 110-type terminal blocks. The strip is snapped in place between the terminal block rows. Label code number 220A (comcode 103970000) contains all of the 110-type labels.

Patch Cord/Jumper Installation and

Administration

Before starting the patch cord installation, obtain a copy of the Port Assignment Record forms from the customer or marketing representative. See Figure 2-25. These forms contain the port assignments and identify the extension numbers (Terminal No.) of the telephones/voice terminals. Enter the jack assignments at the equipment room and indicate if adjunct power is required and where it is provided (MDF, site/satellite closet, or information outlet).