Lucent Technologies Release 6 manual Test Expansion Interface Exchange for Each EPN

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998
4 Test the System
Test Expansion Interface Exchange for Each EPN	Page 4-11

Test Expansion Interface Exchange for

Each EPN

Critical reliability only.

1.Verify the screen displays: Command:

2.Enter status cabinet < 1-44> and press Enter. This displays the standby expansion link (before changes are made). See Screen 4-9.

status system	all-cabinets
		SYSTEM STATUS	CABINET 1
EMERGENCY	SELECT		SERVICE		CABINET
TRANSFER	SWITCH	EXP-LINK	STATE	MODE	TYPE
1A	unavail	01A01-02A01	in	standby	MCC
1B	auto-on	01B01-02B02	in	active
		-
		-

Command successfully completed

Command:

Screen 4-9. Example of System Status Before Expansion Link is Set

3.Type set expansion-link xxxx (where xxxx is the either 1 of the cabinet, carrier, and port locations of the standby expansion link).

4.Verify the screen displays:

Command successfully completed Command:

5.Enter status cabinet < 1-44> and press Enter. See Screen 4-10.

status system all-cabinets
		SYSTEM STATUS	CABINET 1
EMERGENCY	SELECT		SERVICE		CABINET
TRANSFER	SWITCH	EXP-LINK	STATE	MODE	TYPE
1A	auto-on	01A01-02A01	in	active	MCC
1B	auto-on	01B01-02B02	in	standby

Screen 4-10. Example of System Status after Expansion Link is Set