Lucent Technologies Release 6 Channel Service Unit Cabling, 13. DS1 Converter Connections Part

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

TN1654 DS1 Converter (Release 6r Only) Page 5-27

Channel Service Unit Cabling

Figure 5-13 shows a typical connection from the H600-348 Quad Cable to the CSU, through the H600-307 Network Cable, and to the network interface through the Smart Jacks. The double-headed cable plugs into the DS1 converter slot. The quad cable provides up to 4 DS1 connections using a 15-pin connector that plugs into the DTE jack on each CSU. An adapter cable (comcode 107063711) may be required to connect the H600-348 and the H600-307 cables to the CSU.

POWER	AUX PORT COM PORT	MODEM	NETWORK
			DTE

POWER	AUX PORT COM PORT	MODEM	NETWORK
			DTE

POWER	AUX PORT COM PORT	MODEM	NETWORK
			DTE

POWER	AUX PORT COM PORT	MODEM	NETWORK
			DTE

3150csu RBP 062696

Figure Notes

1.H600-348 Quad Cable

2.15-Pin Male “D” Connectors (to DTE Jacks on CSU)

3.Channel Service Unit (CSU)

4.H600-307 Cable (RJ-48C to RJ-48C)

5.Network Interface

6.Smart Jack

7.Cable “A”

8.Cable “B”

9.Cable “C”

10.Cable “D”

Figure 5-13. DS1 Converter Connections — Part 2