Lucent Technologies Release 6 manual Fiber Optic Cable and Adapter

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add the Fiber Optic Cable Page 5-79

4.Pull the tool (with adapter and cable attached) out through the front of the cabinet. See Figure 5-35.

5.From the rear, route the fiber optic cable through the opening vacated by the I/O cable connector.

6.If necessary, remove the fiber adapter from the tool and plug the fiber optic cable into the SC-SC (single-mode) or ST-SC (multimode) adapter. See Figure 5-36. Check the house cabling before selecting a coupling to use.

7.From the front of the I/O connector adapter bracket (with fiber cable), snap the coupling into the supplied I/O connector adapter bracket.

8.Snap the I/O connector adapter bracket into the I/O connector opening.

9.Attach the outside fiber plant to the I/O connector on the rear of the cabinet.

lcda6fop RPY 021698

Figure 5-35. Fiber Optic Cable and Adapter