Lucent Technologies Release 6 manual Issue

DEFINITY Enterprise Communications Server Release 6	Issue 5
Installation and Test for Multi-Carrier Cabinets 555-230-112	May 1998

5Install and Wire Telephones and Other Equipment

Add the Fiber Optic Cable Page 5-73

2.Determine which slot (1 or 2) will contain the new fiber optic circuit pack. Remove the circuit pack or the blanking plate from this slot.

NOTE:

If a circuit pack is removed from the required slot, it must be installed into a different slot in the cabinet. All translations associated with this circuit pack must also be moved.

3.Remove the circuit pack or the blanking plate from the slot next to the slot determined in step 2. Two consecutive open slots are required to install the fiber optic adapter.

NOTE:

If a circuit pack was removed in step 3, it will be replaced into the same slot, later in this section.

4.Install the new circuit pack.

5.Open the rear door.

6.From the rear, remove the I/O cable connector associated with the slot that will contain the new fiber optic circuit pack. See Figure 5-30.

7.Using a supplied cable tie, secure the removed I/O connector to nearby cabling. See Figure 5-31.