Siemens 440 manual Command source, P07003 Selection of command source, Commands, P0700 =

Issue 01/06 Parameter Description

3.8Command source

P0700[3] Selection of command source				Min:	0
CStat:	CT	Datatype: U16	Unit: -	Def:	2
P-Group:	COMMANDS	Active: first confirm	QuickComm.: Yes	Max:	6

Selects digital command source.

Possible Settings:

0Factory default setting

1BOP (keypad)

2Terminal

4USS on BOP link

5USS on COM link

6CB on COM link

Index:

P0700[0] : 1st. Command data set (CDS)

P0700[1] : 2nd. Command data set (CDS)

P0700[2] : 3rd. Command data set (CDS)

Example:

Changing form P0700 = 1 to P0700 = 2 sets all digital inputs to default settings.

Level

1

BOP
Terminals
USS	P0700 = 2
BOP link
USS
COM link
CB
COM link

Sequence control

Setpoint	Motor
channel	control

Caution:

Be aware, by changing of parameter P0700 all BI parameters are reset to the default value or modified as listed in the table below.

If the Inverter is being controlled via the AOP, select USS (with the corresponding interface) for the Command Source. If the AOP is connected to the BOP-Link Interface, then set Parameter P0700 to the value 4 (P0700 = 4).

Note:

Changing this parameter sets (to default) all settings on item selected (see table).

	P0700 = 0	P0700 = 1	P0700 = 2	P0700 = 4	P0700 = 5	P0700 = 6
P0701	1	0	1	0	0	0
P0702	12	0	12	0	0	0
P0703	9	9	9	9	9	9
P0704	15	15	15	15	15	15
P0705	15	15	15	15	15	15
P0706	15	15	15	15	15	15
P0707	0	0	0	0	0	0
P0708	0	0	0	0	0	0
P0731	52.3	52.3	52.3	52.3	52.3	52.3
P0732	52.7	52.7	52.7	52.7	52.7	52.7
P0733	0.0	0.0	0.0	0.0	0.0	0.0
P0800	0.0	0.0	0.0	0.0	0.0	0.0
P0801	0.0	0.0	0.0	0.0	0.0	0.0

MICROMASTER 440	Parameter List
6SE6400-5BB00-0BP0	75