Omron CQM1H-SCB41 operation manual V600-CAjA DIP Switches

V600/V620 ID Controller Protocol Appendix M

V600-CAjA DIP Switches

DIP Switch 1

Note Factory Setting: All OFF

Mode 1

1 2 3 4 5 6 7 8

•Baud Rate Setting

Baud rate (bps)

1200

2400

4800

9600

19200

1=ON, 0=OFF

SW7 and SW8: Be sure to set to OFF.

•Communications Format

	Data	STOP	Parity type
	length (bit)	bit (bit)
	7	2	E
	7	2	O
	7	1	E
	7	1	O
	8	2	N
	8	1	N
	8	1	E
	8	1	O
1=ON, 0=OFF	(See note 1)		(See note 2)

Note 1. Data length setting 7 bits: ASCII code

8 bits: JIS8 unit code

2.Parity setting

E:Even parity

O:Odd parity

N:No parity designation

DIP Switch 2

1 2 3 4 5 6 7 8

•SW8: Receive Side Terminal Resistance Setting (Valid Only for the V600-CA2A)

Connected (ID Controller send side)

Not connected

•SW7: Receive Side Terminal Resistance Setting (Valid Only for the V600-CA2A)

Connected (ID Controller receive side)

Not connected

•SW6: Communications Protocol Setting

1-to-N protocol

1-to-1 protocol

•ID Controller Unit Number Setting (Valid Only for the 1-to-N Protocol) Unit No.

	• Local Communications Mode Setting	No. 0
	Speed priority setting	No. 1
	Distance priority setting	No. 2
		No. 3
		No. 4
		No. 5
		No. 6
•	SW1 Setting	No. 7
		No. 8
	This setting is only valid if the EEPROM-type (battery-
		No. 9
	less-type) Data Carrier (DC) is accessed. The setting
		No. 10
	of SW7 does not work with the SRAM-type (battery-
		No. 11
	type) DC.
•	SW6 Setting	No. 12
		No. 13
	When selecting the 1-to-N protocol for the
		No. 14
	V600-CA1A/RS-232C interface, the setting is limited
		No. 15
	to N=1. In this case, the FCS check code may be add-
		Note 1. Be careful not to set to the same unit number twice.
	ed.
		2. Set them to OFF for the 1-to-1 protocol.

373