Omron CQM1H-SCB41 Delimiter Control Code Setting 3Z4L-4000 Series, 3Z4L-3000 Series

3Z4L Laser Micrometer Protocol Appendix K

•DIP Switch 2

No.	Setting	Status
1	Selection for	ON/OFF
	measurement section
2		ON/OFF
3		ON/OFF
4		ON/OFF
5	Setting of minimum read	ON/OFF
6	value	ON/OFF
7	Display unit	ON/OFF
8	External command	ON/OFF
	setting

Set these settings according to the sensor connected.

Set these settings for

4 digits in the decimal por- tion.

Delimiter Control Code Setting

3Z4L-4000 Series

The delimiter control codes must be set on DIP switch SW1 for the 3Z4L-4000 Series. Turn off pins 4 and 5, set the delimiter codes to CR+LF, and set the delimiter code control setting in the sequence to CR+LF. See the setting for CR+LF in the following diagram.

1 2 3 4 5 6 7 8

Turn OFF.

Turn OFF (to use a general-purpose interface)

Turn ON (to use a general-purpose interface)

Delimiter Setting
Delimiter		CR+LF	CR		LF
Pin
Pin 4		OFF	ON		OFF
Pin 5		OFF	OFF		ON
Handshaking
ON:	Control (recognize DRT input)
OFF:	3-wire method (non-protocol)
Baud Rate
Baud rate		1200	2400	4800	9600
Pin
Pin 1		OFF	ON	OFF	ON
Pin 2		OFF	OFF	ON	ON

3Z4L-3000 Series

The delimiter control code does not need to be set on the DIP switch for the 3Z4L-3000 Series. Set the delimiter

321