Omron CQM1H-SCB41 operation manual Port 2 Restart Bit, Port 1 Continuous Trace Start/Stop Bit

Using Protocol Macros				Section 5-6
Word	Bits	Name and Function	Classifi-	Set	Reset
			cation
IR 207	00	Port 1 Restart Bit	Port sta-	User-set or	After
		The communications port will be restarted when this bit is	tus	STUP(––)	settings are
					changed
		turned ON by the user.
					and port
	01	Port 2 Restart Bit
					restarted
		Same as IR 20700.
	02	Port 1 Continuous Trace Start/Stop Bit	Tracing	From	From
		The CX-Protocol will start a continuous trace when the bit		CX-Protocol	CX-Protocol
		is turned ON. The trace is ended when the bit is turned
		OFF.
		The CPU Unit will manipulate the Shot Trace Bit and
		Continuous Trace Bit when trace operations are performed
		from the CX-Protocol. Do not manipulate these bits directly
		from a ladder diagram.
	03	Port 2 Continuous Trace Start/Stop Bit
		Same as IR 20702.
	04	Port 1 Shot Trace Start/Stop Bit			At end of
		The CX-Protocol will start a one-shot trace when the bit is			short trace
		turned ON. The trace is ended when the bit is turned OFF.
		The Serial Communications Board will be cleared when
		the trace buffer becomes full.
		The CPU Unit will manipulate the Shot Trace Bit and
		Continuous Trace Bit when trace operations are performed
		from the CX-Protocol. Do not manipulate these bits directly
		from a ladder diagram.

05Port 2 Shot Trace Start/Stop Bit Same as IR 20704.

83